Topic Tag: Torsion Chassis

Home /
Viewing 3 topics - 1 through 3 (of 3 total)
    • Topic
    • Voices
    • Replies
    • Last Post
    • Mandarin Monsoon – 1930 Ford Model ‘A’ Pickup The Mandarin Monsoon Hot Rod was made using a Life-Like Hobby Kits 1930 Ford Model 'A' Pickup truck body, BWMS050 motor with 10 x 23 inline gearing, BWA 14 x 5mm wheels, DArt whitewall tires & inserts and other DArt parts, including gas cap & rear transmission detail. The pilot is also DArt. Rear bed has removable mahogany boards. No pickup would be complete without a trailer hitch. This model 'A' also features a Ferrari V8 under the bed...  The chassis is a torsion chassis from piano wire and brass. The body is mounted using a slide in front pin and two wire supports at the rear which clip in place. Exposed suspension areas were chemically treated with Gun Blue. With little torque to worry about the motor was simply epoxied in place. This chassis also uses old school brass tubing in lieu of bearings or bushings. Rear end detail includes a few hand made components. Exhaust pipes are polished aluminium tube. Cheers!

      Started by: AvatarArthur in: Scratch Built Models

    • 6
    • 6
    • 4 years ago

      AvatarLuis Meza

    • Lotus 30 – DArt Body & Scratch Sidewinder Low Power Motor Chassis What better time to get into a Lotus 30 build than now - just in time for the upcoming CANAM Thunder! After some contemplation and a little scavenging then more contemplation it was settled. For this build I would mate the new DArt Lotus 30 body kit with full interior and fantasy livery to a scratch built chassis. I planned to use the following major components: DArt Lotus 30 Body Kit; 'low power' BWNC1 in a sidewinder configuration; Slot.It spur gear with scavenged 15T nylon pinion from some electronic device I threw away many years ago; 2 pair of BWA small 13" (11.85mm diameter) wheels all with DArt DA0211 urethane tires & DArt small inserts (customized); oil lite Parma bushings in the back, 1/8" brass tubes for the front stubs; and scavenged 'push in' guide from a Fly or other RTR scrap chassis. The trouble with making a 'low power' sidewinder model is always the gearing - so when I found the 15T nylon pinion with the correct pitch I couldn't resist. This sidewinder chassis would also be a torsion version using 3/32 piano wire as the spine sleeved by a section of 1/8" brass tube. The defining feature up front for this chassis would be the independent pins allowing the front wheels to have noticeable negative camber. I've wanted to experiment with a front end like this for a long time... if it didn't work then it would be easy enough to replace the sleeves with a straight section of tube. Several extra bits from the body kit are set aside for parts storage - like the larger inserts, clear lenses, short stacks & valve covers - they'll come in handy on another project sometime down the road I'm sure. I plan to use everything else.

      Started by: AvatarArthur in: Scratch Built Models

    • 5
    • 15
    • 5 years ago

      AvatarArthur

  •  

Viewing 3 topics - 1 through 3 (of 3 total)