Viewing topic 1 (of 1 total)
-
- Topic
- Voices
- Replies
- Last Post
-
-
D'Art BRM 578 The Hot Rod Garage was open for business today. I need to solder a pinion gear. Then the motor can be glued in place and wired. It took a lot of extra sanding to get the chassis to fit the back of the body. I had to install the bearings on the inside because the flanges were in the way. I hope to have it running later today sometime. Very little room for the rear body post so it had to be drilled offset. Everything is a super tight fit at the back of the car. But it all fits. Ken
Started by:
in: Scratch Built Models
- 4
- 9
- 3 years ago
Viewing topic 1 (of 1 total)
-