Ferrari – The Happy Canadian Scale Modeler

Viewing 3 topics - 1 through 3 (of 3 total)

- Topic
- Voices
- Replies
- Last Post
- 1956 Ferrari Bardahl Indi-500 Special With the Indi-500 event drawing closer. Some poor guinea pig needs to sort out the rough edges of the class. I came across someone that bought this Geodies resin body and didn't start it. A lucky break. A blind chicken gets a kernel of corn every now and again. That hand written note about using heavy wire as exhaust pipes are the only instructions. You need to figure out the wheelbase and everything else on your own. A windshield was not included in this kit. The wheels, driver, and steering wheel make nice heavy paper-weights. The body weighs 23-grams by itself. It's a bit rough with several pin-holes and buldges. But you can't beat the price. I'm told resin bodies are a bit like egg shells in how they can easily break. 50.8mm max track width might be a tad too narrow for this slow and heavy class. But axles are easy enough to adjust. I'm going to start at 55mm track width and see how it looks. I can cut more off, but can't add it back on if I start too short. We'll find out what the consensus is after the car is built and everyone has had a look at it. I need to sort out the motor and drive shaft next. Where there's a will, there's a way. "Willoughby will, when nobody will!" Or something like that. Ferrari called this car experimental. They weren't kidding. It surely has become an S32 experiment.
  Started by: Ken in: Scratch Built Models
- 5
- 20
- 3 years ago
  Ken
- D'Art Ferrari 312P The first time I laid eyes on Art's Ferrari 312P my brain said "I want that!". Based on using 3/4" aluminum square tubing. I started to rough out a chassis for bearings. Wasn't sure how to attach the body.
  Started by: Ken in: Scratch Built Models
- 4
- 31
- 4 years ago
  Ken
- Ferrari 512 S I bought this car a while ago and it had some problems. The chassis had a broken pod post. I don't have an unlimited car for the up coming Targa Florio so I started this project earlier tonight. I found an interesting way to get a sidewinder mated to an aluminum chassis. The pod is the original from the car. I had to make a small cut to both sides of the motor to get the double-flange bearings to fit. 4-screws and a little epoxy will secure the pod to the chassis. Ken
  Started by: Ken in: Scratch Built Models
- 4
- 8
- 5 years ago
  Ken