Viewing topic 1 (of 1 total)
-
- Topic
- Voices
- Replies
- Last Post
-
-
Lotus 30 – DArt Body & Scratch Sidewinder Low Power Motor Chassis What better time to get into a Lotus 30 build than now - just in time for the upcoming CANAM Thunder! After some contemplation and a little scavenging then more contemplation it was settled. For this build I would mate the new DArt Lotus 30 body kit with full interior and fantasy livery to a scratch built chassis. I planned to use the following major components: DArt Lotus 30 Body Kit; 'low power' BWNC1 in a sidewinder configuration; Slot.It spur gear with scavenged 15T nylon pinion from some electronic device I threw away many years ago; 2 pair of BWA small 13" (11.85mm diameter) wheels all with DArt DA0211 urethane tires & DArt small inserts (customized); oil lite Parma bushings in the back, 1/8" brass tubes for the front stubs; and scavenged 'push in' guide from a Fly or other RTR scrap chassis. The trouble with making a 'low power' sidewinder model is always the gearing - so when I found the 15T nylon pinion with the correct pitch I couldn't resist. This sidewinder chassis would also be a torsion version using 3/32 piano wire as the spine sleeved by a section of 1/8" brass tube. The defining feature up front for this chassis would be the independent pins allowing the front wheels to have noticeable negative camber. I've wanted to experiment with a front end like this for a long time... if it didn't work then it would be easy enough to replace the sleeves with a straight section of tube. Several extra bits from the body kit are set aside for parts storage - like the larger inserts, clear lenses, short stacks & valve covers - they'll come in handy on another project sometime down the road I'm sure. I plan to use everything else.
Started by:
in: Scratch Built Models
- 5
- 15
- 5 years ago
Viewing topic 1 (of 1 total)
-