Topic Tag: Scratch Chassis

Home /

› Forums › Topic Tag: Scratch Chassis

Viewing 3 topics - 1 through 3 (of 3 total)
    • Topic
    • Voices
    • Replies
    • Last Post
    • D'Art Lotus 30 My enthusiasm to build this kit was off the charts. The real Lotus 30 was a terrible car with respect to handling. This is an opportunity to hopefully make it better on a much smaller scale. The real car had chassis flex issues. This chassis does not have those same problems. I had to shorten the top of the front bearing supports because the body sits very low. You can see the 180 grit sanding marks on the inside of the chassis so the epoxy will adhere to the aluminum and motor a bit better. The chassis started out as an inline S-can. That was a huge mistake on such a low car. I should have planned it out better. I hope I never make that mistake again. I had to make a big hole in the body to fit the motor. The colour is Tamiya "Candy Lime Green". Upon assembling the body to the chassis I realized this was indeed a huge mistake. My lack of experience is getting the better of me. Time to take it apart and try something else. I was thinking that I may have already ruined the body. :negative:

      Started by: KenKen in: Scratch Built Models

    • 3
    • 5
    • 4 years ago

      AvatarArthur

    • D'Art Ferrari 312P The first time I laid eyes on Art's Ferrari 312P my brain said "I want that!". Based on using 3/4" aluminum square tubing. I started to rough out a chassis for bearings. Wasn't sure how to attach the body.

      Started by: KenKen in: Scratch Built Models

    • 4
    • 31
    • 4 years ago

      KenKen

    • Lotus 30 – DArt Body & Scratch Sidewinder Low Power Motor Chassis What better time to get into a Lotus 30 build than now - just in time for the upcoming CANAM Thunder! After some contemplation and a little scavenging then more contemplation it was settled. For this build I would mate the new DArt Lotus 30 body kit with full interior and fantasy livery to a scratch built chassis. I planned to use the following major components: DArt Lotus 30 Body Kit; 'low power' BWNC1 in a sidewinder configuration; Slot.It spur gear with scavenged 15T nylon pinion from some electronic device I threw away many years ago; 2 pair of BWA small 13" (11.85mm diameter) wheels all with DArt DA0211 urethane tires & DArt small inserts (customized); oil lite Parma bushings in the back, 1/8" brass tubes for the front stubs; and scavenged 'push in' guide from a Fly or other RTR scrap chassis. The trouble with making a 'low power' sidewinder model is always the gearing - so when I found the 15T nylon pinion with the correct pitch I couldn't resist. This sidewinder chassis would also be a torsion version using 3/32 piano wire as the spine sleeved by a section of 1/8" brass tube. The defining feature up front for this chassis would be the independent pins allowing the front wheels to have noticeable negative camber. I've wanted to experiment with a front end like this for a long time... if it didn't work then it would be easy enough to replace the sleeves with a straight section of tube. Several extra bits from the body kit are set aside for parts storage - like the larger inserts, clear lenses, short stacks & valve covers - they'll come in handy on another project sometime down the road I'm sure. I plan to use everything else.

      Started by: AvatarArthur in: Scratch Built Models

    • 5
    • 15
    • 5 years ago

      AvatarArthur

  •  

Viewing 3 topics - 1 through 3 (of 3 total)