Topic Tag: Stackpipe

Home /

› Forums › Topic Tag: Stackpipe

Viewing 2 topics - 1 through 2 (of 2 total)
    • Topic
    • Voices
    • Replies
    • Last Post
    • D'Art BRM 578 The Hot Rod Garage was open for business today. I need to solder a pinion gear. Then the motor can be glued in place and wired. It took a lot of extra sanding to get the chassis to fit the back of the body. I had to install the bearings on the inside because the flanges were in the way. I hope to have it running later today sometime. Very little room for the rear body post so it had to be drilled offset. Everything is a super tight fit at the back of the car. But it all fits. Ken

      Started by: KenKen in: Scratch Built Models

    • 4
    • 9
    • 3 years ago

      KenKen

    • 1962 BRM P578 'Stackpipe' A wonderful article on the 1962 BRM P578 Stackpipe (attached below). "The best compromise seemed to match the pipe lengths, which meant pointing them skywards, and adding megaphone ends to assist extraction. Thus the slinky 578 gained its famous stackpipes: its most famous feature is a drag-making lash-up."

      Started by: AvatarArthur in: Historical 1:1

    • 1
    • 0
    • 6 years ago

      AvatarArthur

  •  

Viewing 2 topics - 1 through 2 (of 2 total)