For this build, I have used the recently released Dart kit of the Auto Union Type D. As usual, the quality of the kit is second to none and it comes with two driver busts and seat options, large wired inserts and a long styrene tube with two brass push in threaded inserts to be installed as body posts where needed.
I decided to mate the body with an aluminium chassis (KRZ Design) that I made specifically for this model. The BWA 14k ff motor is glued onto the chassis with 5 minute epoxy. I decided to use wired wheels that were purchased from Pendle.
You will note that there is the appearance of significant tire degradation to the front wheels on this model-it wasn’t due to the photo taken after a race. I’ll be replacing these rubber tires that came with the wheels with Dart urethane that will be trued to the same size.
The model as shown in the photos includes the smaller half bust that came with the kit but it is evident that this option requires a thick seat cushion otherwise the driver can barely see over the hood. I’ll be replacing the half bust with a modified full body to achieve the most realistic result.
The model runs very well, and is competitive, with my Auto Union Type C and Mercedes Benz W125. Based on early test results, this type D outpaces the other two.
A new entry for the next Coppa D PGP+ race with Tazio Nuvolari behind the wheel to join Bernd Rosemeyer in the type C and Rudolf Caracciola in the W125.
Thanks for looking.
